Electric Cold Laminator

The electric cold laminator is a cold-mounting machine listed on the company website. It mounts prints onto boards and laminates them in the same pass, without heat, which suits photographs, digital prints and display graphics that heat would damage.

A naming note belongs at the top of this page. The company website's product page is headed as an electric cold laminator, but the configuration table on the same page names the product as an electric pneumatic laminator. Both names are shown here, exactly as published, rather than merged into one. The specification values below are transcribed from that configuration table, which is published as an image on the product page rather than as page text; the transcription is labelled as such.

Specifications

Transcribed from the configuration-parameter image on the company website's product page. The image names the product differently from the page heading; both names are shown.

Reading the Specifications

The published mounting-width options are 1,300 mm and 1,600 mm; confirm the selected option and its price before ordering. Choose a width suitable for your largest prints and confirm the selected machine's dimensions and price before ordering.

Unlimited mounting length means the machine does not limit how long a mounted piece can be; the practical limit is the length of the board and the film being used, and the space available to feed and collect the work. That matters for banners and long display strips, where a length limit would rule the machine out.

Mounting thickness of 20 mm describes the thickest board-and-print combination the machine accepts. That covers foam board and similar display boards, not just thin card. Roller diameters of 130 mm on top and 105 mm below describe the rollers that press the film and board together; larger rollers spread pressure more evenly, which helps on wide work.

Working With Wide Cold Mounting

Cold mounting wide prints is careful work. The print must be aligned on the board before it passes through the rollers, because once the adhesive grips, the print cannot be repositioned without damage. Most operators align the print dry, tack one edge, check the alignment, and then run the board through. Rushing the alignment step is the most common cause of spoiled mounts.

Choosing between the 1,300 mm and 1,600 mm widths is a question of the largest print you mount. The wider machine covers more work, but it also takes more floor space and needs wider film and boards. Compare the complete job width with the published 1,300 mm and 1,600 mm options, and confirm required working margins before ordering. Confirm the film requirements, installation dimensions and price for your selected width before ordering.

Unlimited mounting length sounds like freedom, and it is, but it still needs practical space: a long mounted piece needs somewhere to go as it comes out of the machine, and a long board needs support so it does not bend or drop. Plan the outfeed space as carefully as the machine position itself.